Australian physicists have used the pull of gravity itself to carry information through solid structures in a small-scale demonstration at the University of Queensland.
In the experiment, the team encoded the word "gravity" in binary and transmitted it across roughly 70 centimetres of brickwork by moving a 1950s-style elevator between two floors. Sensors on the receiving side detected minute changes in the local gravitational field caused by the elevator's motion, allowing the researchers to recover the message.
How they did it
The setup was deliberately low-tech: a slowly moving elevator, a brick wall and a corridor that included a men’s bathroom between the transmitter and receiver. By timing the elevator’s position to represent binary bits, the group turned variations in gravitational attraction into a signaling channel. The researchers described the channel as "practically unblockable," noting that gravity cannot be shielded in the way electromagnetic signals can be.
Implications and limitations
The team framed the work as a proof of concept rather than a ready-made communications technology. The transmission was very slow and required careful measurement of extremely small gravitational changes, which places practical limits on data rate and range. Nevertheless, the demonstration underlines that information can, in principle, be transmitted via gravitational interactions and that such a channel would be hard to jam or screen out.
The experiment adds to discussion about unconventional communication methods and the fundamental limits of information transfer. Further work would be needed to assess scalability, sensitivity requirements and potential applications, if any, beyond novelty and foundational physics demonstrations.